:	Jun 17, 2004

.

With assistance, install the transfer case.   Clean the component mating faces.   Lubricate input shaft splines with 'Weicon TL7391' grease.   Install the O-ring seal.   Using the special tool, tighten the bolts to 45 Nm (33 lb.ft).

.

Connect the breather line.

.

Position the fuel line support bracket.   Tighten the bolts to 10 Nm (7 lb.ft).   Secure the fuel lines.

.

Position the selector cable to its guide bracket.

.

Secure the wiring harness to the transfer case.   Secure with the clip.   Tighten the bolts to 25 Nm (18 lb.ft).

.

Connect the electrical connectors.

.

Install the transmission support insulator.   Clean the component mating faces.   Tighten the bolts to 60 Nm (44 lb.ft).

.

Install the rear driveshaft.

.

Install the front driveshaft.

.

Connect the battery ground cable.

.

Use T4 to re-calibrate a new transfer case.